The Patented PMEG:

The PC-PMEG is a sustained energy device; It is a developmental electric transducer, capable of transmitting energy from one system to many types of different systems.  The device creates an AC, three phase current, while varying the frequency, voltage or current as a source of electricity. It produces power at a rate heretofore never seen before in the power generation industry. The PMEG generates power ratios that exceed all current generator capabilities. It is believed that the PMEG will revolutionize the way electric power is generated.

The current PMEG weighs approximately 8 pounds, is 8 inches in diameter and 4 inches wide, however it is scalable. PC is in the process of conducting testing with three new PMEG units, and is building to further establish and demonstrate the technology and it's advanced capabilities.

The PMEG is very versatile and can be used for power in many different industries. The initial application of the technology is for use in the highly efficient PC-PMEG Welding Unit.

 

The Company believes that PMEG technology will have broad applications in the following areas;

  1. Electric and hybrid automobile power and battery recharging systems

  2. General battery recharging systems

  3. Wind power electric generation systems

  4. Solar power electric generation systems

  5. Aircraft battery recharging systems

  6. A power source for a welder (see test analysis below)

 

The Company is able to demonstrate that its PMEG systems will outperform other power sources, and therefore be more desirable than other alternatives. This is due to the PMEG's extremely high efficient, small in size and light weight, with a high-power yield that is comparable to much larger electric generators. The PMEG has no brushes and generates very little heat. The Company plans to market the PMEG technology to the industry segments set out by licensing its technology for the multitude of specific applications.

CERTIFIED TEST COUPON RESULTS;

SAMPLES “COUPONS” OF WELDS PERFORMED BY THE PC-PMEG PORTABLE WELDER, (TWO LEFT HAND TEST SAMPLES) PMEG WELD SHOWS MINIMAL BEND FRACTURE

 

THREE RIGHT HAND TEST SAMPLES PERFORMED WITH 10,000 WATT HOBART WELDER (SEE WELD FRACTURES) HIGH FAILURE FROM THESE SAMPLES

 

ALL TEST SAMPLES CONDUCTED AND CERTIFIED WITH TEST COUPONS ISSUED BY;

AMERICAN PIPING INSPECTION

18501 E Admiral PL, Catoosa, OK 74015 

Web: http://americanpipinginspection.com 

CLOSE UP OF PMEG WELD'S BY JIM MAY